EARTHQUAKE CINENOVA PA-600 (2 X 380) POWER AMPLIFIER
PRICE: 698.00
EARTHQUAKE CINENOVA PA-600 (2 X 380) POWER AMPLIFIER Description
Earthquake Sound's PA-600 can be used in Stereo Mode as two separate power amplifiers, each capable of driving loads down to 2-ohms. Each channel operates independently and has its own input connectors, sensitivity level controls, signal indicator LEDS, limiter circuitry, fault protection circuitry, power amp, and speaker outputs. Special Features Features Input Connections: XLR, RCA, and 1/4" phone (tip/ring/sleeve), one per channel Output Connections: Binding posts & phone jacks Cooling: Variable speed forced air fan cooling rear/side intake, front exhaust Mode Switches: Mono bridge mode select & Limiter "on/off" switch Protection Circuitry: Short circuit, open circuit, RF burnout, over temp, speaker protection relays, turn on/off transient protection, DC protection and limiter circuitry. Pro Audio-600 Model PA-600 Frequency Response +/- 0.5dB, 20Hz to 20kHz Power Per Channel (8-ohm Stereo) 2 x 120 watts RMS @ 8-ohms (Stereo Mode) Power Per Channel (4-ohm Stereo) 2 x 200 watts RMS @ 4-ohms (Stereo Mode) Power Per Channel (2-ohm Stereo) 2 x 300 watts RMS @ 2-ohms (Stereo Mode) Power Per Channel (8-ohm Mono) 380 watts RMS @ 8-ohms (Mono Mode) Power Per Channel (4-ohm Mono) 560 watts RMS @ 4-ohms (Mono Mode) Signal to Noise Ration >98dB ref 200 watts / 4-ohms (20kHz equivalent bandwidth) Input Impedance 2-ohms or greater in stereo mode / 4-ohms or greater in mono mode Channel Separation 100dB Input Voltage (max) 1.5 Volts Total Harmonic Distortion <0.05%, 20Hz to 20kHz Damping Factor Typical 300 (1kHz, 8-ohms) Power Requirements 110 VAC 60Hz, 750VA 100-120 VAC 50/60Hz, 750VA 220-240 VAC 50/60Hz, 750VA Dimension 3 1/2" x 19" x 15 7/16" (HxWxD) 88.8mm x 482.6mm x 392mm Weight 29 lbs. Finish Black Finish
